acrylic black 3 mm (MS0079)

acrylic black 3 mm
width (mm) height (mm) prijs (€)
300 150 €4.79
210 297 €5.98
300 300 €7.66
600 300 €15.33
600 600 €30.65
1200 300 €28.10
900 600 €42.16
1200 600 €51.09
Prices are including 21% vat and excluding cutting costs
Machine dimensions


Also known asperspex
Thickness3.0 mm
Thickness tolerance±0.70 mm
Kerf width0.15 mm
Density1190 kg/m3
Protective Foildefault

Opaque acrylic with a high-quality finish.

Acrylic is hard and relatively stiff, UV-protected and colour-fast.

Typical applications: Acrylic is used mainly for decorative purposes in the advertising industry, in consumer products and in models. Some examples of different applications include:
-façade advertisements
-product displays
-front panels of machines
-low-load mechanical -components

Design: For most applications, acrylic is an easy-to-use material with few issues. When joining the material by means of slots or finger joints, it is important to take the thickness tolerance into account. The sheet thickness can vary by a few tenths of a millimetre; it is therefore advisable to design sufficiently large joints.
Acrylic is a brittle material; it will sooner split or break than become deformed if stresses are too high. To reduce the risk of splitting, inside corners can be rounded off. Flexible joins such as snap-locks and sninges can be made reliable, but must be designed in such a way that the internal stresses in the material do not become too great. Testing and optimising these features before actual production is a must.


Kalashnikoffie by Projekt C

Finishing: Finishing is usually not necessary because of the high quality finish the material has as standard. However, it is very suitable for dyeing or printing. Surfaces can be given a matte finish using fine sandpaper or by sandblasting.

acrylic has a high quality finish

Bonding: It is possible to glue acrylic, but solvent-based adhesives are not recommended for use with laser-cut parts. Acrylic can be easily attached or joined with double-sided adhesive film.

Appearance: Acrylic is particularly well suited for laser-cutting and the process leaves few traces. The cut edge becomes shiny and clear with no discolouration. As there is virtually no melting of the cut edge it is possible to cut fine details.
Surface engraving is possible, leaving a matte white surface in the engraved areas. The protective film is removed before engraving, such that light smoke formation can be observed around the engraving. Line engraving is also possible and results in a clearly visible line.